I am amazed by this DIY raised garden bet planter byAnikas DIY Life.
It was so much cheaper than ordering one online.
Raised garden beds can cost hundreds of dollars online, and this one only costs a fraction of that.
The dimensions can be found in the video down below.
Repeat this process again so you have two long sides.
Step Three
Attach your three short pieces using 22s and exterior screws.
The process will be similar to step one, just using shorter boards.
Repeat this process again so you have two short sides as well.
Anikas DIY Life via YouTube video.
Step Four
Attach the small sides to the long side using the 22s you already screwed on.
Use exterior screws for this as well.
Step Five
Build the legs for the flower bed.
check that you do this on a flat surface to be sure the bed will stand up straight.
Attach the boards with pockets holes so there are no screws hanging out on the sides.
This will also help the legs to hold up longer and be more sturdy.
Step Six
Attac the leg to the flower bed you built in the previous steps.
you could then stain or paint the base as you would like.
Step Seven
Lay the 24s on the base of the flower bed to make a bottom.
Attach them using wood screws.
Step Eight
Now to make it self watering.
Start by trimming and attaching a pond liner to the flower bed using a nail or staple gun.
Place a PVC pipe in one end to water and then a pipe into the other side for drainage.
This DIY is super simple and will save you a lot of money.
