Tis the season to be jolly!
And without a doubt, these sugary sticks will boost your neighbors Christmas spirit.
Then, cut your 2 by 4 wood into pieces that are 3 thick.
Image credit: Isaac Alexander DIY on Youtube
Cut 9-10 bits for the top shape and 7-8 pieces for the bottom figure.
Using a marker, trace onto the front part of the plywood the shape of a candy cane.
Arrange your pieces of wood according to the form.
Then, screw them into place.
Use two screws per wood block.
At the back, screw two pieces of 2 by 4 wood together.
ensure that the wood is shorter in length than the plywood.
Snake your PVC pipe between the top and bottom layers of the mold.
Note that the PVC will get extremely hot, so check that not to burn yourself or the pipe.
Take your PVC out of the mold.
At this point, you now have a 10 foot tall pipe in the shape of a candy cane.
After that, insert your PVC into a jumbo pool noodle.
you gotta have two pool noodles to cover the whole pipe.
Put WD-40 at the top of the noodles for you to easily insert your PVC.
Apply the red stripes to the candy cane using red duct tape.
Start from the top and work your way to the bottom.
Then, wrap the tape at an angle to give a swirl effect.
Do this in a similar swirling fashion.
Work your way from the bottom to the top.
confirm that the connection for the lights hangs at the end of the cane.
Use Gorilla clear duct tape to hold the lights in place.
Hammer a 2 ft rebar 6-8 into the ground.
Slide your candy cane over it.
And there you have it.
You now have a giant LED candy cane to decorate your lawn.
